Concrete Sealer Pro

Description

PureSeal Concrete Sealer Pro is a high solids acrylic sealer designed for sealing block paving, slabs or imprinted concrete. Designed to be tougher and longer lasting than its competitors due to its higher resin content, it is easy to apply by brush, roller or sprayer, and because it is solvent-based, it dries quickly to a tough, finish with a slight sheen on pattern imprinted concrete whilst on block paving, will enhance the colour as if wet.

Depending on the surface you are working with, you can apply concrete sealer pro with a brush, roller or sprayer. A heavy first coat is beneficial on block paving where as lighter coats will be required on pattern imprinted concrete to prevent bubbling. Allow 40 minutes between coats. Apply your second coat 90 to degrees to the first. Clean tools and equipment with xylene after use. Do not use a roller on block paving to prevent spreading sand across the surface. Do not apply this sealer if the ground temperature is over 22 degrees as this will cause the sealer to flash dry and fail.

Remove any excess sand from block paving with a leaf blower before application. Mask and protect delicate surfaces to prevent damage.

• Chemical resistant gloves,
• Eye protection
• Respirator with ABEK P3 filters,
• Overalls

Up to 7m² per litre, per coat, depending on the porosity of the surface